TV antenna satellite dish

How to Turn an Old Satellite Dish Into a TV Antenna
November 2, 2026 – 11:55 am
Satellite Dish Installation

The LNB is the part at the end of the arm.The latest round of analog-to-digital signal conversions that have taken place means that if you are within range of a broadcast television tower, it might be time to switch off the subscription television package you've been buying and go for the free, high-definition, over-the-air broadcasts. Your local television programming will be received just fine like this in many locales. If you find your reception is poor with an indoor antenna, you can adapt your disused satellite dish into an over-the-air TV antenna while also taking advantage of the cables in place.

Step 1

Remove the low noise block converter, or LNB, from the arm of the satellite dish to expose the existing satellite cables. You may have to unscrew the LNB to get it off. Then disconnect the satellite cables from the LNB by unscrewing the cable terminals and pulling the cables through the dish's arm.

Step 2

Clip the amplified outdoor satellite dish clip-on TV antenna onto the top of the dish's rim and then connect the cables you removed from the LNB to the connections on the clip-on antenna. You'll see a set of input and output connectors labeled "In/Out 1, " "In/Out 2" and so on. Usually, you have four sets. Ignore the inputs because they're related to applications for when you want to retain use of the dish. Connect each of the existing wires to the "Outputs." Often, you will have two, but connect them all if there are more.

Step 3

Turn off the television. Connect the one of the cables that was routed from the dish to the satellite receiver's "Input" to the television's coaxial jack often labeled "ANT." Turn on the television and scan for channels.

Step 4

Disconnect the cable you connected in the previous step and connect further cables, one at a time, if the channels you require don't come in properly with the first cable. The cables can be of differing ages, quality and condition. Try each one until you get the best selection of channels and picture quality. Try different permutations on the roof too.

Items you will need

  • Terk TV44 amplified outdoor satellite dish clip-on TV antenna or similar
  • Screwdrivers
Source: techin.oureverydaylife.com
Satellite Oasis DIRECTV SWiM Mobile RV Portable Satellite Dish Tripod Kit SWM SL3S
Speakers (Satellite Oasis)
  • Geniune DIRECTV SWiM HD
  • Complete Portable Kit with Instructions
  • Compatible with H25, HR34, HR44 and above (not C31 and C41)
  • Includes Tripod, 50ft coax, compass, bubble level
  • Handy Satellite Oasis carrying case for accessories
Satellite Oasis Dish Network Turbo Hdtv Satellite Tripod Kit
Speakers (Satellite Oasis)
  • Tripod mounts, 3ft. rg6, 50 ft RG6, Satellite Finder meter,compass, and F81 splice also included.
  • Compatible with all Dishpro and Dishpro plus receivers (2xx,3xx,5xx,6xx,7xx,8xx,9xx series)
  • Dish Network HDTV Satellite Tripod kit for receiving satellites: 110, 119,129w
  • Will operate up to 3 receivers off one dish
  • Blue accessory case included
Satellite Oasis Satellite Oasis Directv Hd Satellite Dish Rv Tripod Kit
CE (Satellite Oasis)
  • Portable Satellite Dish for Directv in HD
  • Compatible with most Directv HDTV satellite receivers (not H25, HR34, HR44, C31,)
  • Device can be set up 50ft. from the RV for easy alignment away from trees
  • Includes 3 LNBF for 99w, 101w, 103w, with four output for 4 receivers
  • Blue Accessories Carrying Case Included
Related Posts